 |
|
|
- Antennas
- Cable
- Lightning Arrestors
- Military & Law Enforcement Antennas
- Pan & Tilt Units
- Tools
- Waveguides
- Double Ridge Waveguide Components
- Waveguide Attenuators
- Waveguide Bends
- Waveguide Circulators
- Waveguide Couplers
- Waveguide Isolators
- Waveguide Power Loads
- Waveguide Sections
- Waveguide Shorts
- Waveguide Single Joint
- Waveguide to Endlaunch Coaxial Adapter
- Waveguide to Right Angle Coaxial Adapter
- Waveguide to Waveguide Transition
- Waveguide Tees
- About Us
- Contact Us
- Facilities
- Partners
- Services
- Support
|
System Controller (Receiver) CRX-100PR: Pan & Tilt Command Receiver  |
Code: CRX-100PR
|
|
The Antenna Factory CRX series of pan / tilt command receivers are interfaced to a computer via RS-485. All connections are via terminal blocks and the unit is able to receive commands to pan, tilt, zoom in, zoom out, focus near, focus far. The unit supports the PELCO™ D protocol.
(see important specifications at next tab) Size: 200 W x 300 H x 150 D (mm)
Input Power: AC110V/220V, 50/60 Hz (Selector Switch)
Temperature: - 10° ~ + 55°
Relative Humidity: RH95% Max
Interface: RS-485
Connection: 5 mm Pitch Terminal Block (10A/300V)
Pan / Tilt Driver: Up, Down, Left, Right, U-L, U-R, D-L, D-R Auto Pan AC110/220V/DC12V AC250V/10A
Speed: None
Preset: 64 Preset Point
Preset Position Reading: Protection meter reading
Motorized Zoom Lens: Zoom-In/Out, Focus-Near/Far DC12V L298
On / Off Control: Light, Aux1, Aux2 : AC Source Voltage OUT On - Off Camera Power : DC12V OUT On - Off
Protocol: PELCO-D-TYPE
|
©2010, Antenna Factory Incorporated. All rights reserved.